Projects / Ideas / Coin cell flasher runtime test

Coin cell flasher runtime test

BeginnerLearningIdeaReviewed
In short

How do you build a coin cell flasher runtime test?

Run a self-blinking LED from a CR2032 and a holder, and note how long it stays visibly bright. You learn how current draw sets battery life, and why a coin cell is only good for tiny loads. Never charge a coin cell, and keep it away from small children. You need Flashing LED 5 mm (self-blinking), CR2032 coin cell, CR2032 coin cell holder, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 40 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Estimate how long a coin cell can run a tiny flasher.

How to build it

  1. Fit the cell in the holder with the right side up
  2. Connect the flasher with a series resistor
  3. Note the start time
  4. Check brightness every few hours
  5. Record when it fades and compare with an estimate from the cell capacity

Related projects

Common questions

What parts do I need for the coin cell flasher runtime test?

Flashing LED 5 mm (self-blinking), CR2032 coin cell, CR2032 coin cell holder, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the coin cell flasher runtime test take to build?

About 40 minutes for a beginner maker.