RC phase-shift oscillator
To design an RC phase-shift oscillator for a given frequency and measure its output frequency.
Theory
Three RC sections give 180° phase shift at f = 1/(2πRC√6), and the inverting amplifier gives another 180°, so the loop is in phase. The RC network attenuates by 1/29 at that frequency, so the amplifier gain must be at least 29 (Barkhausen criterion: loop gain ≥ 1, total phase 360°).
Apparatus
- IC 741 (or BC547 for the transistor version)
- Resistors
- Capacitors 0.01 µF × 3
- Dual supply ±12 V
- CRO
Circuit connections
- Op-amp inverting amplifier with Rf ≥ 29R; its output feeds three RC sections in a ladder back to the inverting input
Procedure
Pre-lab check
4 questions · 75% to be readyTry the readings before the lab
| Quantity | Value |
|---|---|
| f = 1 / (2πRC√6) | 999.6 Hz |
| Minimum gain | 29 |
| Minimum Rf for this R | 188.5 kΩ |
Precautions
- Use matched capacitors.
- Start with slightly more than the minimum gain to avoid a distorted output.
My readings
Type what you measured. It goes into your record book, and to My Garage when you are signed in.
| S. No. | Quantity | Value |
|---|---|---|
| 1 | ||
| 2 | ||
| 3 | ||
| 4 | ||
| 5 | ||
| 6 |
Check my readings
Put the value you set in the first column, then compare. Real parts have tolerance.
Your lab record
Everything above is free. The print-ready write-up comes with Maker.
Printed pages leave the observation table empty for your own readings.
Viva practice
Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.
Quick answers for your record and viva
What is the aim of the rc phase-shift oscillator experiment?
To design an RC phase-shift oscillator for a given frequency and measure its output frequency.
What apparatus is needed for rc phase-shift oscillator?
IC 741 (or BC547 for the transistor version), Resistors, Capacitors 0.01 µF × 3, Dual supply ±12 V, CRO.
What is the theory behind rc phase-shift oscillator?
Three RC sections give 180° phase shift at f = 1/(2πRC√6), and the inverting amplifier gives another 180°, so the loop is in phase. The RC network attenuates by 1/29 at that frequency, so the amplifier gain must be at least 29 (Barkhausen criterion: loop gain ≥ 1, total phase 360°).
What result should I get in rc phase-shift oscillator?
Designed frequency ___ Hz, measured ___ Hz.
What precautions should I take in rc phase-shift oscillator?
Use matched capacitors. Start with slightly more than the minimum gain to avoid a distorted output.
