Fault finder: Yogurt box thermometer

11 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No DS18B20 found: what should I check?

Check the three wires and the 4.7 kilo-ohm pull-up.

Reads 85 degrees: what should I check?

The probe has just started, wait for the next reading.

Display blank: what should I check?

Check the OLED address 0x3C and that ssd1306.py is on the Pico.

No beep: what should I check?

Check the buzzer is passive and on GP15.

Temperature looks wrong: what should I check?

Check the probe is not touching the side of the box or a heater.