Fault finder: Soil probe powered only when reading

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Screen blank: what should I check?

Try address 0x3D and check SDA and SCL.

Reading never changes: what should I check?

Check AO is on A0 and the probe is powered from D7.

Percentage backwards: what should I check?

Swap DRY_RAW and WET_RAW values you measured.

Readings jump: what should I check?

Increase the delay before reading or press the prongs deeper.

Probe is green or crusty: what should I check?

It was powered too long, replace it and keep the on-demand power.