Fault finder: Wi-Fi LED strip controller with WLED
6 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Wrong colours: what should I check?
Change the colour order in LED preferences.
First LED flickers: what should I check?
Check the level shifter and the 330 Ω resistor.
Strip resets when bright: what should I check?
Lower the current limit or use a stronger supply.
Cannot find it on Wi-Fi: what should I check?
Check the 2.4 GHz network and the credentials.
