Fault finder: Wire gauge voltage drop lab

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Drop reads much larger: what should I check?

A bad contact, so twist and clamp the joints firmly.

Drop reads zero: what should I check?

The meter is on the wrong range, or the probes are across the resistor.

Resistor too hot: what should I check?

Shorten the test or let it cool between readings.

Pack voltage sags: what should I check?

The cells are tired, so use fresh ones.

Readings drift: what should I check?

Wire and resistor warm up, so read quickly.