Fault finder: Wien bridge sine oscillator
7 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No output: what should I check?
Increase the gain setting; check pins 8 and 4 have power.
Clipped output: what should I check?
Reduce the gain or check the diodes are fitted both ways round.
Wrong frequency: what should I check?
Check R1, R2, C1 and C2 values and that the series and parallel arms are in the right places.
Hum or noise: what should I check?
Add a 100 nF capacitor from each supply pin to ground and keep leads short.
