Fault finder: Servo needle voltmeter

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Needle twitches: what should I check?

Add the capacitor or power the servo separately.

Reading wrong: what should I check?

Set CAL against a multimeter and check the module's signal pin.

Needle at the end stop: what should I check?

The voltage is above FULL_SCALE_V. Lower the input.

Reading never changes: what should I check?

Check the ground link between the module and the Nano.