Fault finder: Zener and transistor regulator

6 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output about 0.6 V: what should I check?

The zener is the wrong way round. Cathode (band) goes to the base.

Output equals the input: what should I check?

Base resistor and zener are not connected to the same node.

Transistor very hot: what should I check?

Load is too high. Reduce it or fit the heatsink.

Output drops sharply under load: what should I check?

The base current is starving the zener. Use a smaller resistor.