Fault finder: Voltage divider explorer

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output is zero: what should I check?

The ground connection is missing or the probes are in the wrong sockets.

Output is the full 9 V: what should I check?

R2 is not connected to ground.

Readings differ from calculation: what should I check?

Resistors are 5 % off and the battery sags. Measure the actual values.

Pot gives odd readings: what should I check?

Check you used the middle pin as the output and outer pins as the supply.