Fault finder: UV index meter for the terrace

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading stays at zero outside: what should I check?

The sensor is behind glass, which blocks UV, or the OUT wire is not on A0.

Readings jump around: what should I check?

Average more samples and keep the sensor wires short.

Display is blank: what should I check?

Swap CLK and DIO, and check the 5 V supply.

LED shows the wrong colours: what should I check?

You have a common anode RGB LED. Join the long leg to 5V and invert the analogWrite values.