Fault finder: USB isolator for safe probing
5 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Board not found: what should I check?
Power the board separately and re-plug the isolator.
Upload fails: what should I check?
Slow baud rate; try another USB port.
Messages garbled: what should I check?
Check the baud rate is 9600.
