Fault finder: Tap water turbidity checker

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading always the same: what should I check?

Check the signal wire and that the probe is in water.

Values drift: what should I check?

Keep the same depth and let it settle for a few seconds.

Thresholds do not match: what should I check?

Re-measure your own glasses and edit the constants.

Screen blank: what should I check?

Check the I2C connection.