Fault finder: Precision voltage divider with a trimmer

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output does not change: what should I check?

Check you are on the middle pin.

Output stuck at an end: what should I check?

Check both end pins are connected through the resistors.

Reading jumps: what should I check?

Loose breadboard contact, press the trimmer in.

Numbers differ from the calculation: what should I check?

Measure the supply and the real resistor values.

Clicking while turning: what should I check?

The trimmer has reached the end of its travel.