Fault finder: Common-emitter transistor amplifier

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Collector near 9 V: what should I check?

Transistor is off. Check the base divider and pins.

Collector near 0 V: what should I check?

Transistor is saturated. Check the 100 kΩ resistor value.

Distorted output: what should I check?

Input is too large. Turn the potentiometer down.

No output: what should I check?

Check both coupling capacitors' polarity and positions.