Fault finder: Model tram stop announcer

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Player not found message: what should I check?

Check TX and RX, the SD card and its format.

Wrong stop plays: what should I check?

Check the file names start with four digits.

Clicks or resets: what should I check?

Add a 100 microfarad capacitor across the player's power.

Too loud: what should I check?

Lower the volume number in the code.

Buttons do nothing: what should I check?

Check they go to D2 or D3 and GND.