Fault finder: Tone decoder remote switch

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED always on: what should I check?

Input is too loud or timing is wrong. Lower the input level.

LED never lights: what should I check?

Check the frequency against 1.1 ÷ (R × C) and pin 3 coupling.

Flickers: what should I check?

Increase the loop filter capacitor on pin 2.

Chip hot: what should I check?

Supply is too high. Keep it at or below 9 V.