Fault finder: CMOS 555 against bipolar 555
8 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No blink: what should I check?
Check pin 4 is on the rail and pins 2 and 6 are joined.
Blink too fast: what should I check?
Check the 10 uF capacitor value and polarity.
Current looks high: what should I check?
Disconnect the LED when measuring the chip.
Meter reads zero: what should I check?
Check the red lead is in the mA jack for current.
Readings jump: what should I check?
Add the 100 nF capacitor on pin 5.
