Fault finder: Thevenin equivalent lab
7 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Short-circuit reads low: what should I check?
The meter has some resistance on the mA range; allow for a small error.
Meter reads zero current: what should I check?
Wrong socket or a blown fuse.
Numbers differ from the example: what should I check?
Use your measured battery voltage and resistor values.
Battery drops under load: what should I check?
Use a fresh battery.
