Fault finder: Newton cooling curve lab

13 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads -127: what should I check?

The probe is not wired or the pull-up is missing.

Reads 85: what should I check?

A power-on default, check the 5V wire and the pull-up.

k looks negative: what should I check?

Room temperature was wrong, restart in air.

Display blank: what should I check?

Check I2C address 0x3C.

Curve is noisy: what should I check?

Keep the probe still and out of draughts.