Fault finder: Terminal block hub board

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

A terminal does not beep: what should I check?

Re-tighten the screw and check the wire is under the clamp.

Positive beeps to ground: what should I check?

A loose strand is touching, strip and remake that joint.

Voltage is low: what should I check?

Check the supply and the wire gauge.

Wire pulls out: what should I check?

Strip a little longer and tighten harder.

Sensors plug in wrongly: what should I check?

Keep the three-pin order the same on every block.