Fault finder: Ice and boiling point calibration

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

DS18B20 reads -127: what should I check?

Check the 4.7 kΩ pull-up and the wiring.

NTC reads odd values: what should I check?

Check which side the 10 kΩ resistor is on in the divider.

Ice reading not zero: what should I check?

Stir the slurry and keep the probe off the walls.

Boiling reading far off: what should I check?

Check the altitude constant and that the water is truly boiling.