Fault finder: Superposition two-source lab
5 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Sum does not match: what should I check?
A source was not replaced by a wire to ground, or a joint is loose.
Readings drift: what should I check?
The cells are tired, so use fresh ones.
Voltage is much lower: what should I check?
Check the 4.7 kilohm resistor is connected to the ground rail.
Battery gets warm: what should I check?
Check there is no short between its plus and minus.
Meter reads negative: what should I check?
Swap the probes.
