Fault finder: Supercapacitor charger and LED runtime test

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Voltage rises slowly: what should I check?

Normal; check the resistor is 10 ohm, not 10 k.

LED very dim: what should I check?

The cap is below 1.8 V; that is the end of its use here.

Cap warm: what should I check?

Stop; check polarity.