Fault finder: Desktop stereo speakers with PAM8403

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Hum or buzz: what should I check?

Share the signal ground and keep the signal wires short.

One channel silent: what should I check?

Check that speaker's connections and the pot section.

Sound distorts when loud: what should I check?

The USB supply is too small. Use a 5 V 2 A source.

Loud pop at switch-on: what should I check?

Turn the volume down before powering.