Fault finder: Stepper motor that follows a knob
7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Motor buzzes but does not turn: what should I check?
Wrong pin order. Use 8, 10, 9, 11 as in the code.
Shaft jitters at rest: what should I check?
Raise the dead band (8) to 16 so noise on A0 is ignored.
Very weak: what should I check?
The 28BYJ-48 is a small geared motor. Lower setMaxSpeed to 500 for more torque.
