Fault finder: 8-step sequencer synth

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Pots interfere: what should I check?

Check the INH pin goes to ground and the pot ends are on 5 V and GND.

Wrong step order: what should I check?

Check the A, B, C pins against the X0 to X7 order.

Quiet sound: what should I check?

Use a passive buzzer and a short wire.

Notes click: what should I check?

Lengthen the gap between notes.