Fault finder: SPI daisy chain of displays

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Only the first module works: what should I check?

Check DOUT to DIN links on the later ones.

Displays reversed: what should I check?

Swap the device numbers in the code.

Dim or flickers: what should I check?

Use the 5 V adapter, not the Nano pin.

Garbled characters: what should I check?

Check that CLK and CS go to every module.