Fault finder: Soldering practice board

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Solder will not stick: what should I check?

Clean and tin the tip and heat the pad as well as the lead.

Bridge between pads: what should I check?

Use the wick to remove excess.

Circuit does not run: what should I check?

Check the 555 orientation and the capacitor polarity.

Lifted pad: what should I check?

You held the heat too long; use a wire link to the next point.