Fault finder: SMD soldering practice

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Part flies away: what should I check?

Hold it down while the first side cools.

Solder balls up: what should I check?

Add flux and clean the tip.

Pad lifts: what should I check?

Use less heat and time.

Bridges everywhere: what should I check?

Use less solder and more flux.