Projects / Electronic dice / Fault finder

Fault finder: Electronic dice

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Some segments never light: what should I check?

Check the pin order and that each resistor is in the circuit.

Wrong digit shapes: what should I check?

The display may be common anode, invert the pattern bits with a tilde.

Segments are dim: what should I check?

Use 220 ohm instead of 330 ohm resistors.

Same number appears often: what should I check?

Leave A0 unconnected so it floats.

Display lights all segments always: what should I check?

The common pin is not connected to GND.