Fault finder: Series and parallel resistors

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading is lower than expected: what should I check?

Your fingers are in parallel with the resistor. Hold only the leads' insulated bodies.

Reading unstable: what should I check?

The probes are not touching firmly. Press them on the leads.

Big difference from calculation: what should I check?

The wrong resistor or a misread band. Measure each one first.

Meter shows OL: what should I check?

The circuit is open. Check the connections on the breadboard.