Fault finder: Serial plotter sensor lab

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Temperature reads strange: what should I check?

TMP36 is wired backwards. Check which side the flat face is on.

Plotter shows one line: what should I check?

The output is not in name:value format or the line ends are missing.

Noisy traces: what should I check?

Add 100 nF across the sensor supply and keep wires short.

Nothing shown: what should I check?

Wrong baud rate on the plotter.