Fault finder: Electronic tamper-evident seal

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Opens by itself: what should I check?

Check the wire joint and its pull-up.

No blink: what should I check?

Check LED polarity and the 220 Ω resistor.

Count wrong: what should I check?

Use the correct fuse and clock settings.

Chip never sleeps: what should I check?

Check the watchdog setup.