Fault finder: Pet door that knows your cat
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Tag not read: what should I check?
Hold it flat near the coil.
Servo buzzes: what should I check?
Check the latch travel.
No ID in the monitor: what should I check?
Check D2 and the baud rate of 9600.
Door relocks too early: what should I check?
Lengthen the open time.
