Fault finder: Roaming pet toy robot

13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Spins on the spot: what should I check?

Check the motor wiring direction.

Hits walls: what should I check?

Check the sensor aim and raise the 20 cm distance.

Flap stuck: what should I check?

Adjust the servo angle.

Does not stop when lifted: what should I check?

Check the tilt switch orientation.