Fault finder: Robot that follows you

9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Robot spins or twitches: what should I check?

Motors wired backwards; swap the pair on that side.

Never follows: what should I check?

Check the HC-SR04 pins and that you are within 100 cm.

Chases a wall: what should I check?

Ultrasonic sees the wall; keep the area clear or lower FOLLOW_MAX.

IR always on: what should I check?

Trimmer too sensitive; turn it down.

Uno resets when motors start: what should I check?

Weak cells or a loose connection; fully charge the cells.