Fault finder: Resistor tolerance sorting lab

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Readings jump around: what should I check?

Press the probes firmly and keep fingers off the leads.

Reading shows OL: what should I check?

Use a higher range.

Reading far from the mark: what should I check?

Check the colour bands, it may be a different value.

Meter reads about 0.2 on a short: what should I check?

Subtract the probe resistance.

All readings similar but off: what should I check?

Your meter may be out, try another.