Fault finder: Resistor value reader
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Value wrong: what should I check?
Check which pin goes to which reference.
Jumpy: what should I check?
Add 100 nF from A0 to ground and average more.
Colours off by a band: what should I check?
Check the multiplier calculation.
No display: what should I check?
Check the OLED wiring and address.
