Fault finder: Colour code reading drill

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading looks ten times out: what should I check?

You mis-read the multiplier band.

Reading low: what should I check?

Fingers on both leads, or a part in a circuit.

Cannot tell brown from red: what should I check?

Use good light and a white card behind the resistors.

Cannot tell which end to start: what should I check?

Start from the end away from the gold band.

Meter shows 1 or OL: what should I check?

Choose a higher range or check the lead contact.