Fault finder: Two-player reaction duel
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
The LED never lights: what should I check?
Check its direction and that its resistor goes to D4.
A press is never detected: what should I check?
Buttons must go between the pin and GND, and the sketch uses INPUT_PULLUP.
The display stays blank: what should I check?
Check CLK and DIO are on D6 and D7 and the library is installed.
Times always show 0: what should I check?
A button is stuck closed. Check wiring and that you released both before the round.
