Fault finder: RC time constant with a stopwatch

6 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Time much too short: what should I check?

The capacitor was not fully discharged.

Time much too long: what should I check?

Check the resistor is 100 kilohm and the capacitance is right.

Voltage never reaches the target: what should I check?

Leakage or a faulty capacitor, try another.

Reading looks backwards: what should I check?

Check the capacitor polarity.

Times vary: what should I check?

Average three runs and use the same meter range.