Fault finder: Interactive rangoli light mat
6 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Pads always on: what should I check?
Raise the threshold.
Pads never trigger: what should I check?
Use a thin hard spacer so the FSR is squeezed.
Wrong spot lights: what should I check?
Check the PAD_LED numbers.
LEDs flicker: what should I check?
Check the data resistor and the capacitor.
