Fault finder: Tipping-bucket rain gauge

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Count jumps by two or more: what should I check?

Increase the debounce or move the magnet.

No count: what should I check?

Check the reed switch position and the D2 wire.

LCD blank: what should I check?

Try address 0x3F and adjust the contrast trimmer.

Total wrong: what should I check?

Recalibrate MM_PER_TIP with a measured volume.