Fault finder: PWM fan hub for a PC case
12 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Fans stay at full speed: what should I check?
The probe reads -127, so check the 4.7 k resistor and the three probe wires.
Fans do not turn: what should I check?
Check the diode and the fan wires, and that the MOSFET legs are gate, drain, source from the left with the flat side facing you.
Nano resets when the fans start: what should I check?
Keep the 5 V converter separate from the fan wires and add a 100 uF capacitor across the Nano power.
Whining from the fans: what should I check?
PWM can make a hum on some fans, so raise DUTY_MIN or try a different T_LOW.
Screen blank: what should I check?
Check SDA and SCL and try address 0x3D.
