Fault finder: Pull-down versus pull-up inputs

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

A or B reads the wrong way: what should I check?

Check which side the resistor and the button go to.

Both LEDs stay dark: what should I check?

Check the LED direction and the 220 ohm resistors.

C looks steady: what should I check?

Hold a finger near the wire, or touch the metal lead.

Readings are always 1: what should I check?

Check the button is not stuck or wired across 5V and D4.

No serial text: what should I check?

Set 9600 baud.