Projects / Solar lantern / Fault finder

Fault finder: Solar lantern

8 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Does not charge: what should I check?

Check polarity and that the panel gives over 5 V in sun.

LED too dim: what should I check?

Reduce the series resistor a little and check the current.

LED on in daylight: what should I check?

Swap the LDR and the 10 kΩ resistor.

Cell gets warm: what should I check?

Disconnect and check for a short.