Fault finder: DIY power bank with charge display

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No output: what should I check?

Check B+ and B- polarity and that the module's input is set up for its cell count.

Pack gets hot: what should I check?

Stop at once. Check the cells, polarity and load.

Level reads wrong: what should I check?

The indicator is for a different cell count. Match it to 1S.

Only one cell charges: what should I check?

The cells were at very different voltages. Recheck and balance them separately first.