Projects / Rheostat LED dimmer / Fault finder

Fault finder: Rheostat LED dimmer

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED does not light: what should I check?

Check the LED direction and the supply.

Current jumps while turning: what should I check?

The wiper contact is dirty, turn it back and forth.

Meter reads zero: what should I check?

Check the red lead is in the mA jack.

LED flashes at the pot ends: what should I check?

The wiper is not joined to terminal 3.

LED very bright at one end: what should I check?

Check the 220 ohm resistor is still in series.