Fault finder: Posture reminder clip

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Angle does not change: what should I check?

The axes are wrong for your mounting. Try atan2(ax, az) or atan2(ax, ay).

Motor does not vibrate: what should I check?

Check the BC547 pins and that the motor is on 3V3 and the transistor's collector.

Resets when the motor starts: what should I check?

The coin motor draws a surge. Add a 100 µF capacitor on 3V3.

Battery does not charge: what should I check?

The BAT+ and BAT- pads are swapped. Check polarity.